On grade from the first pass. TOPCON 3D-MC2 GRADER helps motor graders respond instantly to cutting edge movement, delivering automatic corrections that improve grading speed, accuracy, and surface consistency. The result is less rework, lower fuel consumption, and more productive operation across demanding grading conditions.
TOPCON 3D-MC2 GRADER is an advanced machine control solution for motor graders designed to achieve faster finish grading, tighter tolerances, and smoother automatic blade control. With real-time correction, strong sensor compatibility, and stable grading performance, it supports efficient operation across road construction, site development, and complex grade transitions.
TOPCON 3D-MC2 GRADER is built for contractors and grading crews who need faster finish grading, tighter control, and automatic corrections in real time without compromising surface quality.
The system continuously tracks cutting edge movement and applies automatic corrections immediately, helping the grader stay closer to target grade from the start of each pass.
TOPCON 3D-MC2 GRADER is designed for stable finish grading at higher operating speeds while maintaining tight tolerances and smooth blade behavior.
Fast response and continuous position sensing help reduce undercutting and support more consistent finish grading across different working conditions.
The system supports satellite-based positioning workflows and integrates with a wide range of Topcon sensor technologies for flexible site control.
The control system is built for rapid sensing and correction, helping the grader maintain smoother blade control and more stable grade performance at working speed.
Fast hydraulic response helps the system correct grade changes smoothly, supporting automatic blade control through transitions and varying surface conditions.
TOPCON 3D-MC2 GRADER supports fully automatic motor grader control, helping operators work faster with improved consistency and reduced manual correction.
Built-in tilt compensation adjusts automatically for blade position changes caused by mold board roll, helping maintain the intended grade during different blade angles and working styles.
The system works with a broad range of Topcon technologies, making it suitable for contractors using both 2D and 3D positioning methods across different jobsites.
The solution is designed for straightforward installation and calibration, helping crews get the system configured and ready for production with minimal delay.
TOPCON 3D-MC2 GRADER helps operators finish grade faster, reduce grading errors, and maintain tighter control across flat grades, steep slopes, and transition areas.
By sensing cutting edge changes immediately and correcting automatically, the system helps graders reach target grade faster with fewer corrective passes. Best for reducing fuel use, time, and repetitive grading effort.
Stable automatic control allows finish grading at higher speeds while maintaining tighter tolerances and smoother blade behavior. Best for contractors who need speed without sacrificing grade quality.
Compatibility with Topcon 2D and 3D technologies allows the system to work across laser, sonic, LPS, GPS, and Millimeter GPS workflows. Best for fleets and projects with mixed positioning requirements.
TOPCON 3D-MC2 GRADER is ideal for finish grading applications where speed, smoothness, automatic correction, and tight tolerances are critical to productivity.
Suitable for road construction, site development, and other finish grading projects where high productivity and tighter tolerances are required. Ideal for fast, accurate final grade work.
Works with slope sensing to maintain strong grading accuracy from flat areas to steep slopes and through transition zones. Ideal for projects with changing surface geometry.
Suitable for contractors who may need GPS, LPS, laser, sonic, or Millimeter GPS depending on site conditions and positioning requirements. Ideal for adaptable fleet and site grading workflows.
TOPCON 3D-MC2 GRADER is a strong fit for contractors and operators who need fast, automatic, and accurate finish grading performance across demanding grading applications.
Helpful for operators who want smoother, faster finish grading with less manual correction and better automatic grade control.
Useful for contractors who want to improve grading productivity, reduce undercutting, and work to tighter tolerances on every pass.
A strong fit for fleets that need compatibility across GPS, laser, sonic, LPS, and Millimeter GPS grading workflows.